Johnson & Starley Ltd. Heat Bank Thermal Store Units Installation, Commissioning, Servicing, & Users Instructions Heat Bank Thermal Store System GX - Direct Rapid Publication ZZ             14/10/00 Copyright DPS 1788-6

Heat Bank Thermal Store System   Everest combination unit   Single Heat Exchanger (30 ltr/min)   Directly heated from remote source   35mm Foam Insulation   GX-Plan primary controls   Directly Pumped Heating Circuit   Fitted programmer   Fitted Primary Pump, 5m head   All fitted controls are wired   Thermostatic Blending Valve 22mm   Backup Immersion Heater   1   Integral Feed & Expansion Tank 2   Plate Heat Exchanger 3   Heat Exchanger Pump 4   Flow Switch 5   Thermostatic Blending Valve, Mixcall III 6   Manual Air Vent 8   Filling Vent 9   Feed to Ball Valve 10  Isolating Valve 11  Y-Pattern Strainer (supplied loose) 12  Overflow (supplied loose) 13  Cold Feed / Expansion 14  Immersion Heater 3kW Incaloy with Stat 16  Cold Mains In, 22mm 17  Hot Mains Out, 22mm 18  Drain Cock 19  Flow From Boiler 20  Return to Boiler 23  Flow to Heating Circuit 24  Return from Heating Circuit 27  Boiler Pump UPS 15/50 28  Heating Circuit Pump UPS 15/60 33  Programmer Danfoss CP715 34  Room Thermostat Danfoss RMT230 (supplied loose) 38  Cylinder Immersion Thermostat Danfoss ITC 40  Tight Fitting Lid 41  Primary Blending Valve 42  Wiring Centre   Unit ID HBPP-130-GX HBPP-150-GX HBPP-180-GX HBPP-210-GX HBPP-250-GX Capacity 130 150 180 210 250 Base Diameter 450 450 450 450 450 Overall Diameter 520 520 520 520 520 Height 1190 1330 1510 1720 1980

Contents: 1. Introduction 2. General Requirements 3. Mains Water Supply 4. Connections: 5. Wiring 6. Filling 7. Commissioning 8. Fault Finding 9. Servicing 10. Spares 11. User Instructions