|
|||||||||||
R/O Shops, 9-19 Manor Green Road, Epsom, Surrey KT19 8RA |
|||||||||||
|
|||||||||||
Heat Bank Thermal Store System Stowaway advanced F+E 14 Plate Heat Exchanger (30 ltr/min) Indirect 40mm Foam Insulation High duty primary coil Y-Plan primary controls Smartfit Controls All fitted controls are wired Manual Fill - No Overflow Backup Immersion Heater Low Water Level Indicator Cased
1 Integral Expansion Vessel (Unpressurised) |
|
||||||||||
The unit is fitted with an Integral Overflow Chamber [8], which traps small volumes of water discharged as a result of overfilling. Water in the chamber can be drained off via the Overfill Drain Cock [66]. The unit MUST be watched during filling as excessive overfilling will result in over-spill onto the floor. |
The unit is fitted with one heat exchanger, capable of delivering 30 litres/minute @45°C (80°C
storage). The graphs shown the domestic hot water output that can be achieved for various storage temperatures.
|
A Mains Water Isolating Lever Valve must be fitted within the cylinder cupboard, in clear view and easily accessible. A Strainer (supplied loose) must also be fitted, down stream of the isolating valve, to protect the flow switch [4]. |
It is advised that the mains water is tested for hardness. In areas of hard water, we advise the use of a scale inhibitor. |
It is important that SENTINEL X100 Inhibitor is used to protect the Heat Bank Thermal Store. Use 1 litre per 100 litres of stored water. A suitable anti-freeze, such as X500, should also be added when there is a chance that the unit will be left filled and unheated in freezing conditions. |
Smartfit Honeywell, has swept aside the traditional problems and hassles associated with controls wiring and significantly reduced installation time and costs into the bargain. At the centre of Smartfit is a new connection box which provides plug-in or simple 2-wire connection for all space heating and hot water controls, completely eliminating the need for complex wiring diagrams. All the controls have been designed for low voltage, polarity free connection. Servicing is quicker, chances of error are reduced to the minimum, and can be achieved with total confidence. The elegant Smartfit controller puts easy programming and diagnostics at your fingertips. A built-in commissioning sequence and simple manual overrides assure maximum user convenience. The unique built-in diagnostics programme automatically indicates a fault in the system and highlights where the fault lies, cutting out guesswork and hassle and saving valuable time. Extensive information, including can be obtained from the Honeywell Web Site http:// honeywell1.datareturn.com/UK/homes/smartfit.htm |
IMPORTANT:
BOILERS CAN ONLY BE SOLD AS PART OF A PACK. |