A
system designed to run in conjunction with a gas boiler, a solid fuel
boiler, electric heating, and solar panels, this unit will also provide
mains pressure hot water as well as central heating to two independent
temperature controlled zones.
Heat Bank Thermal Store System Xcel Cylinder 28 Plate Heat Exchanger (45+ ltr/min) Directly heated from remote source 40mm Foam Insulation
GX-Plan primary controls Directly Pumped Heating Circuits
(x2) RF Programmable Room Thermostat
s (x2) Fitted Primary
Pumps Fitted Solar Controls (exc.
relief & vessel) All fitted controls are wired Thermostatic Blending Valve 22mm Additional 6m Finned
Solar Coil Connections for Solid Fuel Boiler Backup Immersion Heater
Overheat Protection (dump
to heating) Cased
Unit Code |
XC-250-4089-1 |
Capacity [litres] |
250 |
Base Diameter [mm] |
450 |
Overall Diameter [mm] |
530 |
Height [mm] |
1800 |
1 Remote Feed and Expansion Tank 2 Plate Heat Exchanger 3 Heat Exchanger Pump 4 Flow Switch 5 Thermostatic Blending Valve, Mixcall III 7 Automatic Air Vent 8 Vent 11 Y-Pattern Strainer (supplied loose) 13 Cold Feed / Expansion 14 Immersion Heater 3kW
Low Noise with Stats 16 Cold Mains In, 22mm 17 Hot Mains Out, 22mm 18 Drain Cock 19 Flow From Boiler 20 Return to Boiler 23 Flow to Heating Circuit 24 Return from Heating Circuit 27 Boiler Pump UPS 15/60 28 Heating Circuit Pump UPS
15/50 33 Danfoss Radio Receiver
34 Danfoss Programmable Radio Room Stats 38 Cylinder Thermostat (with Immersion Pocket) 39 White Coated Steel Casing 41 Primary Blending Valve 48 Check Valve 49 Solar Drain Point 50 Solar Pump 51 Flow from Solar Panels 52 Return to Solar Panels 53 Resol Solar Controller 64 Connections to
Solid Fuel Boiler 72 Overheat Thermostat 73 Solar
Sensors 80 Solar Filling Point 81 Dosing Pot Connection
|
|